Internal friction associated with ? martensite in shape memory steels produced by casting route and through additive manufacturing: Influence of thermal cycling on the martensitic transformation.

Abstract

Among the different families of shape memory alloys (SMA), the Fe-Mn-Si-Cr-Ni alloys have attracted a renewed interest because of its low cost, high corrosion resistance and high recovery strength during the shape memory effect, and the new technologies of additive manufacturing offer unforeseen possibilities for this family of SMA. In the present work, the reversible gamma - epsilon martensitic transformation (MT), responsible for the shape memory effect, is studied in two Fe-Mn-Si-Cr-Ni alloys with high (20.2 wt%) and low (15.8 wt%) Mn content, produced by the conventional route of casting and rolling, in comparison with the MT in another similar alloy, with intermediate Mn content (19.4 wt%), which was produced by gas atomization and additive manufacturing through laser metal deposition. The forward and reverse gamma - epsilon MT is studied by mechanical spectroscopy through the internal friction spectra and the dynamic modulus variation, together with a parallel microstructural characterization including in-situ observation of the gamma - epsilon MT during cooling and heating at the scanning electron microscope. The evolution of the transformed fraction of epsilon martensite, evaluated through the integral area of the internal friction peak, was followed along thermal cycling in all three alloys. Both, the internal friction and the electron microscopy studies show that the epsilon martensite amount increases very fast during the first few cycles, and then decreases with a tendency towards its stabilization for many tens of cycles. The results show that the gamma - epsilon MT is more stable on cycling in the additive manufactured sample than in the conventionally processed samples, opening new avenues for designing shape memory steels to be specifically processed through additive manufacturing.