Full metadata record
DC Field | Value | Language |
---|---|---|
dc.creator | Alaña-Olivares, M. (Markel) | - |
dc.creator | Lopez-Arancibia, A. (Aitziber) | - |
dc.creator | Ghouse, S. (Shaaz) | - |
dc.creator | Rodriguez-Florez, N. (Naiara) | - |
dc.creator | Ruiz-de-Galarreta-Moriones, S.(Sergio) | - |
dc.date.accessioned | 2023-03-21T10:44:04Z | - |
dc.date.available | 2023-03-21T10:44:04Z | - |
dc.date.issued | 2022 | - |
dc.identifier.citation | Alaña-Olivares, M. (Markel); Lopez-Arancibia, A. (Aitziber); Ghouse, S. (Shaaz); et al. "Additively manufactured lattice structures with controlled transverse isotropy for orthopedic porous implants". Computers in Biology and Medicine. 150 (105761), 2022, | es |
dc.identifier.issn | 0010-4825 | - |
dc.identifier.uri | https://hdl.handle.net/10171/65752 | - |
dc.description.abstract | Additively manufactured lattice structures enable the design of tissue scaffolds with tailored mechanical properties, which can be implemented in porous biomaterials. The adaptation of bone to physiological loads results in anisotropic bone tissue properties which are optimized for site-specific loads; therefore, some bone sites are stiffer and stronger along the principal load direction compared to other orientations. In this work, a semi-analytical model was developed for the design of transversely isotropic lattice structures that can mimic the anisotropy characteristics of different types of bone tissue. Several design possibilities were explored, and a particular unit cell, which was best suited for additive manufacturing was further analyzed. The design of the unit cell was parameterized and in-silico analysis was performed via Finite Element Analysis. The structures were manufactured additively in metal and tested under compressive loads in different orientations. Finite element analysis showed good correlation with the semi-analytical model, especially for elastic constants with low relative densities. The anisotropy measured experimentally showed a variable accuracy, highlighting the deviations from designs to additively manufactured parts. Overall, the proposed model enables to exploit the anisotropy of lattice structures to design lighter scaffolds with higher porosity and increased permeability by aligning the scaffold with the principal direction of the load. | es_ES |
dc.language.iso | eng | es_ES |
dc.publisher | Elsevier | es_ES |
dc.rights | info:eu-repo/semantics/openAccess | es_ES |
dc.subject | Lattice structures | es_ES |
dc.subject | Transverse isotropy | es_ES |
dc.subject | Orthopedic implants | es_ES |
dc.subject | Additive manufacturing | es_ES |
dc.title | Additively manufactured lattice structures with controlled transverse isotropy for orthopedic porous implants | es_ES |
dc.type | info:eu-repo/semantics/article | es_ES |
dc.description.note | This is an open access article under the CC BY license | es_ES |
dc.identifier.doi | 10.1016/j.compbiomed.2022.105761 | - |
dadun.citation.number | 105761 | es_ES |
dadun.citation.publicationName | Computers in Biology and Medicine | es_ES |
dadun.citation.volume | 150 | es_ES |
dc.identifier.pmid | 36126355 | - |
Files in This Item:
Statistics and impact
Items in Dadun are protected by copyright, with all rights reserved, unless otherwise indicated.